Interested in Custom Products from Elo? Learn More
Interested in Solutions from Elo? Learn More
SAW (IntelliTouch® Surface Acoustic Wave)
Number of Touches
FingerGloved handPassive stylus
2.36" x 3.51" x 0.61" / 59.94 mm x 89.03 mm x 15.44 mm
USB (Full Speed) Plug and play compatible
Approximately 4096x4096, size independent, 255 levels of Z (pressure)
Approximately 10.4 ms per coordinate set.
+4.75 to +5.25 VDC
+5 VDC, nominal (+4.75 to +5.25 VDC)
MTBF greater than 345,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for the ground benign environment with an ambient temperature of 25°C
Four-layer surface-mount design with internal ground plane for EMI suppression
The printed circuit board substrate is rated 94V0. All plastic components, such a headers and connectors, are also rated 94V0.
Shock and Vibration
Three axis sine wave, 50Hz to 2kHz, 1G, 2 minutes/Octave with dwell on resonance
Per EN 6100-4-2 1995: Level 4. Contact discharge 8kV, air discharge 15kV.
0°C to 65°C
IntelliTouch SmartSet protocol
Initial/Stream/ Untouch/ Z-axis Enable Modes
-25°C to 85°C
Operating: 10% to 90% RH, noncondensing Storage: 10% to 90% RH, noncondensing
30,000 hours demonstrated
All mounting holes are plated through-holes for chassis ground connection. Refer to the drawings at the end of this document.
Connectors and Pin Definitions
The connector configuration permits the controller to be placed in-line between the touchscreen and a USB hub or host attachment.
Contact Elo for more information.